TANK LOADING SPECIFICATION
300 Gallon Hydroseeder Tank Mixing SOP & Loading Recipe
Field-proven tank loading sequence and mixing ratio recipe for 300 gallon hydroseeding equipment. Designed for Tow-Behind & Landscape Utility Rigs rigs requiring fast hydration and preventing nozzle clogging.
Interactive Field Slurry & Tank Load Estimator
Adjust your project acreage and slope gradient below for instant material load calculations.
GreenTack Tackifier
100 LBS
(2 Bags)
ViscoLok EFM Mulch
2,500 LBS
(50 Bags)
Total Water Needed
5,000 GAL
Slurry payload
Total Tank Loads
5 LOADS
Trips to water source
Step-by-Step Operator Loading Sequence
- Fill Tank to 75% Water Level: Engage mechanical agitator at 100–150 RPM before introducing dry materials.
- Sift GreenTack / ViscoLok: Pour powder gradually across the recirculating vortex over 60 seconds. Mineral spacers prevent lump formation.
- Introduce Seed & Fertilizer: Mix thoroughly for 60 seconds once polymers are dispersed.
- Top Off Water & Agitate: Fill to capacity and agitate for 3 – 5 Minutes. Hydrophobic anti-foam prevents slurry overflow.
Loading Recipe: 300 Gallon Tank
- Water Volume: 300 Gallons
- GreenTack Hydrocolloid: 3 – 6 lbs
- ViscoLok EFM Hydromulch: 100 – 150 lbs
- Agitation Benchmark: 3 – 5 Minutes
- Max Coverage Area: Up to 0.4 Acres (17,424 sq ft)
Max Pumping Distance & Hose Friction Matrix
| Hose Inner Diameter | Max Hose Length | Pressure Drop (PSI / 100ft) | Slurry Flow Rating |
|---|---|---|---|
| 1.5 Inch Rubber Hose | Up to 150 Feet | 18–22 PSI | Good for small turrets |
| 2.0 Inch High-Flow Hose | Up to 350 Feet | 10–14 PSI | Recommended for civil slopes |
| 3.0 Inch Heavy-Duty Hose | Up to 600+ Feet | 4–7 PSI | Optimal for extreme DOT cuts |
Field Troubleshooting Guide
| Field Symptom | Likely Cause | Immediate Job-Site Fix |
|---|---|---|
| Slurry Too Thick / Hard to Pump | Exceeded recommended loading ratio | Add 50 gallons water & agitate 2 mins |
| Foam Overflowing Tank Hatch | High-shear agitation air entrainment | GreenTack maintains a low-foaming profile during high-shear agitation |
| Nozzle Spitting or Clogging | Commodity tackifier agglomerations (fisheyes) | GreenTack's dispersion modifiers prevent fisheye formation |